How to Choose Feed Ring Die
Do you want to know how to be successful in the feed pellet mill? Do you want to know what is the most important part when you start a feed pellet business? This article will answer all of your questions.
Online, August 19, 2013 (Newswire.com) - As we all know that pellet business has become more and more popular in the world, so more people began to pay attention to pellet mills. However, the die of pellet mill is the most important part of all the plant, so choose a suitable die is an essential project. Especially in the feed pellet plant.
According to the incomplete statistics, the cost of wear and tear of ring die takes up 30% of the maintenance cost for the whole workplace and the quality of feed pellet has an great influence on feed sales. So it is very important for feed producers to know how to choose the ring die. In the following, we will give an introduction.
Ring die is a kind of porous and ring wear part, whose wall is thin and die hole is densely covered. In addition, the assembly dimension is precise. Ring die is made of carbon steel or ally steel or stainless steel by forging, machining, drilling die hole and heat treatment process.
At present, the quality of the ring die in the domestic market mainly depends on the different selection, the different process and the different control. In the small factory, the ring die is mainly made by forging, drilling die hole withe the twist drill and then common heat treatment. Under the circumstance, there are many problems, such as the new mould must be approved by the long time of washing process, high energy consumption, low yield, the poor pellet and so on. What is worse, the service life is short and it is wearing. In addition, according to a survey, the iron content of feed is higher because of the usage of ring die.
Finally, it will affect the formula of feed.
In a word, the result is caused by the poor wear resistance of the ring die.
As we all know, when China joins in the World Trade Organization, only the good and cheap feed has strong competitiveness. So it is an urgent need for feed produceers to educe the cost and improve the quality of feed pellets. While, all the above is up to quality of the ring die.
According to the working conditions, the producer should choose the stainless steel ring die. Because the service life of stainless steel is long. In addition, the die hole should be made by the gun drill in order to make die hole smooth. What is better, the ring die by vacuum heat treatment can be chosen in order to keep high wear resistance, high strength and the smoothness of die hole. Finally, it can guarantee the quality of pellets.
To sum up, it is a key for manufacture and supplier of feed pellet equipment with rich experience, have a whole feed pellet production line to serve your diversified needs.